What five steps to monitor the force value deformation system of the tensile tester?

forTension testerThis special high-tech testing equipment is very important for testing in terms of mastering force value numbers. The following are the operating steps of the monitoring force value deformation system provided by Jinan Hengsi Shengda Instrument Co., Ltd.:

1. Zero point, force value, deformation calibration: The instrument has been adjusted before leaving the factory, and under normal circumstances there is no need to adjust it.

2. Basically, the operator judges the yield strength and tensile strength of the sample based on the tensile gauge in front of the tensile tester and the external large deformation extensometer. The numerical errors read by different personnel are also relatively large. It is a domestically renowned test instrument with advanced model technology, high automated water products, and high testing accuracy. Widely used in rubber, plastic, pipe, canvas, aluminum profiles, wires and cables, plastic films, steel wires, cords, copper, metal and non-metallic materials and other related industrial materials. Control can automatically obtain conventional data such as elastic modulus, yield strength, tensile strength, fracture strength, sample elongation, cross-section shrinkage, etc.

three,Tension testerThere are two wiring sockets behind the system, one is an analog force value signal input socket, and the other is an analog deformation signal input socket. After plugging in the power socket and the signal input socket, the system can be powered on. When the power is turned on, press the "Clear All" key, and you can see a display of 0000.00 in the display window of the front panel of the instrument, indicating that the instrument is working normally.

4. Tension testing machine is an important equipment for detecting the mechanical properties of materials. Whether the welded pipe produced by the welded pipe unit is an indispensable task to use the tensile machine to check the yield strength and tensile strength of the welded pipe.

5. The zero-flood calibration method is: press the "Clear All" key when the holder is not loaded.

MoreTesting machineAll information is in Jinan Hengsi Shanda Instrument Co., Ltd.