6 steps to connect the test machine to the hydraulic system

The hydraulic system isTesting machineThe specific operation of important equipment and equipment is explained below for customers to understand.

(1) Remove the bundles in each part and clean kerosene to clean the inside of the oil pipe, especially the threaded threads of the connecting ports of each oil pipe.

(2) Check whether the gasket at the joint is complete. If it is damaged due to transportation reasons, use the new gasket included in the test machine to prevent oil leakage during high pressure.

(3) Use a suitable wrench to connect each oil pipe. If it is a seamless copper pipe, it should be connected to the main machine and rely on the movement of the console to adjust the spacing to connect to the console end.

(4) Remove the residual oil in the fuel tank and remove the residue in the fuel tank.

(5) Uncover the iron door of the hydraulic control box and you can see the wire mesh oil filter. When filling the oil, it is poured into the oil tank through this oil filter. The test machine usually uses hydraulic oil. Hydraulic oil with higher viscosity should be used in summer and hydraulic oil with lower viscosity should be used in winter.

(6) Be sure to pay close attention to the oil level when refueling. The tester cannot work normally if the oil volume is too small. Too much oil volume will cause hydraulic oil to leak from the working cylinder port.

MoreMaterial testing machineAll information is available at Jinan Hengsi Shanda Instrument Co., Ltd.