6-step maintenance operation of drop test machine

6-step maintenance operation of drop test machine

A lot has been told on my company's website earlierUniversal testing machine,Impact testing machineFor operation and maintenance, below is the explanation of Jinan Hengsi Shanda Instrument Co., Ltd. for the maintenance of the fall test machine during use:

1. After the test is completed, drop the drop arm to avoid stretching and deforming the spring for a long time, affecting the effect of the test. Before performing the drop test, you can press the drop key after the motor stops rotating at the reopening position;

2. The new machine is installed at the factory for completion. Appropriate low concentration of engine oil should be added to the sliding round rod. It is prohibited to add anti-rust oil or high concentration of engine oil and backlog of corrosive oils;

3. After a long period of dust accumulation in the oiling area, the machine can be lowered to the lower part, wiped the old engine oil, and put clean engine oil;

4. The drop machine test machine is an impact mechanical equipment. When the new machine is used more than 500 times, the screws need to be re-tightened to avoid failure during subsequent use;

5. The lifting shaft and chain of the drop test machine need to be regularly added to lubricating oil; the gear reducer changes oil once every six months;

6. Non-operators are not allowed to operate the machine at will. The power supply must be cut off when there is no need to work, and the lifting shaft must be clean.

MoreMaterial testing machineInformation related to the information is all in Jinan Hengsi Shanda Instrument Co., Ltd.