Revealing the test process of simple supporting beam impact testing machine

Customers know about simple support beamsImpact testing machineIt is a common equipment for scientific research institutions and related factories and mines to conduct quality inspections. It has a wide range of applications, and the test methods used for different models of impact testing machines are different. The following is an introduction to the test methods of the simple-supported beam impact testing machine:

The test thickness was measured according to GB6672, and a point was measured at the center of all samples, and the arithmetic average of 10 samples were taken.

Put the sample flat and clamp it in the clamper. The sample should not be wrinkled or the surrounding tension should be too large. The impact surfaces of 10 samples should be consistent. Hang the pendulum on the release device, press the key on the computer to start the test, and let the pendulum impact the sample. The same step is to perform 10 tests. After the test is completed, the arithmetic average of the 10 samples is automatically calculated. Select a punch according to the required pendulum impact energy for the test, so that the reading is between 10% DD90% of the full scale 3. Calibrate the instrument according to the rules of the simple-supported beam impact test machine instrument.

With the above information, I believe that the simple support beam has beenImpact testing machineUnderstand and personal reminder, you should pay special attention when using it