How to install a relaxation test machine and what methods should be mastered during installation?

The prerequisite for ensuring normal use of the equipment is to have a professional and correct installation method, and the relaxation test machine is no exception. To ensure its efficiency in use, you must first prepare for installation. So how should you install the relaxation test machine and what methods should you master during installation? Let’s see the introduction below.

Installation method of relaxation test machine:

The relaxation test machine needs to be installed in a room with clean, dry, no vibration and room temperature standard. At the same time, it is necessary to pay attention to leaving enough space around the test machine so that it can be convenient for use and maintenance; the main body of the equipment needs to be installed on the concrete foundation, and the foundation size needs to be specified according to the appearance and foundation map standards. Related devices such as anchor screws and lower jaw screws and other wire installation pipes need to be reserved.

The plane on the foundation must be flat. You can rectify it by a leveling ruler. After the foundation is dried, you will install the test machine. After installation, you need to make preliminary accuracy correction. At this time, you can place the main body on the concrete foundation, and then adjust the good distance and direction between the main body and other equipment according to the appearance and foundation map.

After the preliminary accuracy of the slack test machine is corrected, the oil pipe and power supply can be turned on for preliminary trial operation. If the test operation is good, the accuracy of the equipment can be corrected. When correcting, a square horizontal instrument needs to be leaned against the working platform, and after the plumb slurry of the oil cylinder is corrected or increased to reduce the cushion under the machine base. The error must be controlled within the standard range. After the equipment accuracy is determined, the gap under the machine base needs to be blocked with cement slurry, so as to maintain the effective combination of the machine base and cement, thereby preventing the equipment from being level due to vibration during use.

After the anchor nut is poured firmly, if the cement has not dried yet, the anchor nut cannot be tightened, and the equipment cannot be run. After the cement is completely dry, tighten the nut. The installation accuracy of the equipment needs to be checked again to see if it can match the corrective accuracy.

This is how to install the slack test machine, and what methods should be mastered during installation? I hope that such content can help everyone effectively ensure the accuracy of equipment installation. Of course, here we also remind everyone to follow the standards when installing, and also pay attention to the quality of the equipment itself.