Detailed steps for jumper configuration of material torsion test machine

Sensor is a detection device that is used inMaterial torsion test machineThe testing equipment plays an important role. Jinan Hengsi Shengda Instrument Co., Ltd. has made a detailed understanding of the jumper device in the material torsion test machine:

Sensor link speed creates communication speeds between the working computers, the mechanical control modules of the digital controller, and the loading unit control panel. Processor Speed ​​Creates the sensor processor speed. The sensor link and processor are located on the TI/O RAM daughterboard and loading unit.

/// Jumper configuration

Use the table below to determine the jumper used for all sensor processors and links on the TI/O daughterboard.

* If the wire length between the digital controller and the working computer or the loading unit control panel exceeds 100 feet (30 meters), the link speed should be reduced to 10MHz.

* The link speed of all digital controller modules should be configured the same.

Jumping pin

Processing speed

Link speed (MHz)

Jumping pin

MoreMaterial torsion test machineAll in Jinan Hengsi Shanda Instrument Co., Ltd.