Methods for handling abnormal vibration, noise, data abnormality and other faults in electronic tension testing machine

The electronic tensile tester is a model with accurate test accuracy in the test machine. Its degree mainly depends on the accuracy of the control part, the accuracy of the transmission part, and the sensitivity of the sensor. It can be said that the sensor occupies an important low position in the entire mass system of the electronic tensile tester. However, even if the performance of the machine itself is good, it will be useless to not know how to solve it after encountering a failure. So, what should I do if the electronic tensile testing machine fails?

Conventionally, as long as you ensure that the base is stable and the components are connected and tight when installed, there will be no major problems when operating. However, if the installation is not in place, abnormal vibration and noise are likely to occur. If the operation is not standardized, it will also affect the accuracy of the test data. Based on years of experience, our technical staff have summarized the following points for everyone, regarding the handling methods of abnormal vibration, noise, data abnormality and other faults in the electronic tensile testing machine, to help everyone solve similar problems.

1. Abnormal vibration and noise of the electronic tension tester

1) Please check whether the four legs of this machine are in contact with the pedestal evenly. If not, please adjust the four legs to make the pedestal evenly contact.

2) Check whether the system power supply voltage is normal and stable. If not, please replace the stable normal power supply.

3) Check whether the screws on each part of the machine are loose. If they are loose, please tighten the screws.

2. The test data of the electronic tension test machine is abnormal

1) Please first determine whether the clamping of the "test piece" is true. If not, please confirm.

2) Please check whether the settings of "Strength Sensor" and "Decoder" are correct. If not, please refer to the operating instructions and the settings are completed.

3) Please check whether you press "Strength Reset Key" and "Deformation Reset Key" before the test starts. If there is no, please start the test again and press "Strength Reset Key" and "Deformation Reset Key" before the test.

The above is the method of handling abnormal vibration, noise, data abnormality and other faults in the electronic tension testing machine shared by the editor. I hope it can help everyone!