Force value verification of electronic universal testing machine

Electronic universal testing machineThe force value verification is a series of steps to make the force value of the electronic universal testing machine meet the requirements of the corresponding standards. Usually, this operation is operated by the manufacturer and the quality supervision bureau. Users do not need to master it, but it is also good to learn it.
1. Enter the program with an administrator and open "Information Management" and "Sensor Verification";
2. Set the checkpoint and detection value, select the detection channel (the default is the force channel), and select the number of detection groups (the default is the three groups);
3. Click "OK" in the "Check Point Settings" page and enter the calibration;
4. Turn on the electronic universal testing machine and click "Run" on the running control panel.
5. When the load of the electronic universal tester is close to the point of calibration (check), the slow speed is manually controlled (if it is automatically loaded, click the slow speed in the "Check Interface". When it reaches the point of calibration (check), tap the "Space Bar" on the keyboard to record this point;
6. Repeat step 5 to record the points to be calibrated (checked) in sequence;
7. After a set of verifications is completed, the program will automatically stop running (click "End" at this time, and the calibration run interface will be exited and the "Show calibration results" interface will be entered). Click "Run" again to perform the next set of verifications;
8. When the three sets of verification are completed, the program will automatically exit to the "Show verification results" interface.
Check the calibration error. If the error exceeds the standard, please correct the calibration code.

For more test machine materials, please pay attention to the official website of Jinan Hengsi Shanda Instruments: http://www.hssdtest.com/

Contact number: 0531-81901322