System connection of universal testing machine

The universal material tester checks whether the gasket at the joint is complete. If it is damaged due to transportation reasons, it should be installed with the new washer included in the tester to prevent oil leakage during high pressure; use a suitable wrench to connect each oil pipe. If the electronic universal tester is seamless copper pipe, it should be connected to the main machine and rely on the movement of the console to adjust the spacing to connect to the console end. Remove the residual oil in the oil tank and remove the residue in the oil tank; uncover the iron door of the hydraulic control box and you can see the wire mesh oil filter. When filling the oil, it is poured into the oil tank through this oil filter. The test machine usually uses hydraulic oil. The electronic tension test machine should use hydraulic oil with higher viscosity in summer and hydraulic oil with lower viscosity in winter; be sure to pay close attention to the oil level when refueling. The tester cannot work normally if the oil volume is too small. Too much oil volume will cause hydraulic oil to leak from the working cylinder port.
After the standard performance testing, the universal tester has summarized some of the main advantages of the tester operation. The entire system service connection is something to pay attention to. Don’t take it so carelessly when using it. Ruima will take you to learn more about news you cannot understand.
Remove the bundlings from each part, clean kerosene and clean the inside of the oil pipe, especially the threaded threads of the connecting ports of each oil pipe;